User's Manual

ACCESS POINT
12
Step B
1. Open the SNMP Manager application. If you haven’t installed SNMP Manager
application, please refer to the Installing SNMP Manager section.
2. Connect to the access point by selecting
Connect AP
,
which is a submenu under
File
menu. Type the IP address of the access point (which has been temporarily set
in Step A) in the panel that appears. Type “
public
” at the
password
field; select
“
Administrator
” in the
authority
combo-box and then press “OK”. The SNMP
manager will inform you that the access point has been found and that all the
configuration values have been retrieved.
3. Under the
Setup
⇒ Bridge
submenu, select
IP Configuration
. Type the IP address
that was set up in
Step A
in the configuration window that appears. Confirm the
validity of the other values (MAC Address and subnet mask), and select the
primary port that determines the access point’s MAC Address and IP, then press
“OK”.
4. Save the configuration by selecting “Download Changes” under the
File
menu. The
IP address of the access point has now been set permanently.
DHCP client
If DHCP client is enabled, the IP address field displays the IP address that was
dynamically assigned to the access point by the DHCP server. The
Subnet Mask
field
displays the subnet mask utilized by the network DHCP server. Select the primary
port that is the interface which determines the DHCP server and press “OK”. If the
network server failed to give an IP address to the access point, then the default IP
address will be assigned to the access point.
If you have problem in configuring your AP correctly, then follow the appropriate
link(s) above to seek further information regarding setting and configuring your AP.
Otherwise, you may proceed to the Using SNMP Application usage section on
information describing on how to use the application utility.