User's Manual

ACCESS POINT

To connect to a central LAN, tick the

Preferred BSS

check box and enter the MAC

address of the central LANs AP. If you don’t know the MAC address of the central

LANs AP, click on

Site Survey

and then on

“Get / Refresh”

button. A list of the

available APs will appear. Click on the SSID of the AP you wish to connect to and

click the

Connect

button. In addition to setting the preferred BSS, you also need to

make sure that the remote AP has the

same

ESSID

as yours.

Figure 21 - Access Point Client setting

Wireless Bridge:

Two types of connection are available under this mode.

a. Point to Point: The wireless bridge can communicate with a specific remote

MAC address.

b. Point to Multipoint: The wireless bridge can communicate with any wireless

bridge available in the

same channel

. When authorization algorithm is enabled,

the wireless bridge can communicate with any wireless bridge whose MAC

addresses exists in the

authorization table