User's Manual

ACCESS POINT

7.2 Connection Troubleshooting

VI receive this error message when I try to find access point.

Solution

: Check the following:



AP is powered on and connected

If AP is powered on but you still can’t find the access point, then you have

probably have or set the APs IP address to one of the invalid addresses. To fix the

problem, you need to

reset

the AP. Refer to resetting AP section for more

information on how to reset your AP.

Note

: If you are using wireless LAN to connect to the access point, then there is a

higher chance of you not able to detect the AP. Try to use Ethernet to connect to

the access point.

I can’t connect to an AP.

Solution

: Check the following:



Access point is powered on and connected.



Access point is connected to the

same

subnet as your Ethernet station. Refer to

tutorial section if you are unfamiliar with subnet and subnet settings.



Both you and the access point have a valid IP address. Refer to validating IP

address section to check if you have a valid IP address.