User's Manual

ACCESS POINT
51
7.3 Resetting the Access Point
Resetting the access point will restore the factory settings.
WARNING
:
All the settings you made to the access point will be lost after
resetting the device
.
To reset the AP, use a pin or something small to push and hold the reset button. Reset
button is located on the reverse side of the AP. Resetting procedure should take no
more then 10 seconds. After the device has been reset, you need to reconfigure its IP
and saving it again. Refer to configure AP
if you have problems setting APs IP using
ARP command.
The Bottom of the AP Diagram