User's Manual

ACCESS POINT

Federal Communications Commission Interference Statement

FCC Class B Certification

The device complies with Part 15 of the FCC rules. Operation is subject to the

following conditions:

1. This device may not cause harmful interference.

2. This device must accept any interference received, including interference that

may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interference

to radio communications However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more of the

following measures:



Reorient or relocate the receiving antenna.



Increase the separation between the equipment and receiver.



Connect the equipment into an outlet on a circuit different from the one which the

receiver is connected.



Consult the dealer or an experienced radio/TV technician for help.

CAUTION:

To assure continued FCC compliance:

(1) The user must use shielded interface cable and shielded power cord.

(2) Any changes or modifications not expressly approved by the grantee of this

device could void the user's authority to operate the equipment.

FCC RF Radiation Exposure Statement

This equipment complies with FCC RF radiation exposure limits set forth for an

uncontrolled environment. This equipment should be installed and operated with a

minimum distance of 20cm between the radiator and your body.

CE Market Declaration of Conformance

This is to certify that this product complies with ISO/IEC Guide 22 and EN45014. It

conforms to the following specifications:

EMC: EN55022(1988)/CISPR-22(1985) Class B

IEC 61000-4-2(2000) 4kVCD/8k VAD

IEC 61000-3-3(2000) 3V/m

IEC 61000-4-4(2000) 1kV-(power line)

IEC 61000-4-6(2000) 3Vrms

IEC 61000-4-11(2000) 3Vrms

The product complies with the requirements of the Low Voltage Directive 73/23/EEC

and the EMC Directive 89/336/EEC, and carries the CE Mark accordingly.