User's Manual
Table Of Contents
- Preface
- Read Me First
- About This User Guide
- Chapter 1 Getting Started
- Chapter 2 Using the E500RM8
- Chapter 3 Using Winmate® Home Manager (WHM)
- Chapter 4 Connecting to Network and Devices
- Chapter 5 Using Camera
- Chapter 6 Capturing Data
- Using Barcode Reader
- Location
- Android Winmate® Data Collection (WDC)
- Where To Find WDC?
- How to Turn On/Off the Power of Barcode Reader
- How to change the symbologies of Barcode
- How to add command to my output of the barcode
- How to change the scan type for the Barcode Reader
- How to change the setting of the application WDC o
- Scanning the barcode
- Scanning Tips and Considerations
- Using Smart Card Reader
- Using Fingerprint Scanner
- Using Barcode Reader
- Chapter 7 Accessories
- Appendix A: Product Specifications
- Appendix C: Software Development Kit
- Appendix D OS Image Update
E500RM8 User Guide
9
3. Locate the SD card holder.
4. Push the SD card holder in the direction of the arrow to unlock it.
5. Pick and raise the SD card holder up in upright position and then put the SD Card into the
socket.
Battery Installation
Inserting the standard Battery Pack into the device:
1. Disconnect AC adapter and power cord from the device.
2. Turn the device over, back facing up.
3. Locate the Battery Lock Latch and push it to the “Unlocked” position.
4. Locate the Battery Release Slider that is spring-loaded. Pull back and hold.
5. Insert the battery on the connector-pins side first, and then lower the battery into the battery
compartment. Continue to hold the Battery Release Slider before battery is fully inserted.
6. Make sure the battery is completely lowered into the compartment before letting go the Battery
Release Slider. Battery will be flat against the housing once fully inserted.
Reinsert the battery by latching the bottom first (1) and then
pushing the battery pack down (2).