User's Manual
Table Of Contents
- Preface
- Read Me First
- About This User Guide
- Chapter 1 Getting Started
- Chapter 2 Using the E500RM8
- Chapter 3 Using Winmate® Home Manager (WHM)
- Chapter 4 Connecting to Network and Devices
- Chapter 5 Using Camera
- Chapter 6 Capturing Data
- Using Barcode Reader
- Location
- Android Winmate® Data Collection (WDC)
- Where To Find WDC?
- How to Turn On/Off the Power of Barcode Reader
- How to change the symbologies of Barcode
- How to add command to my output of the barcode
- How to change the scan type for the Barcode Reader
- How to change the setting of the application WDC o
- Scanning the barcode
- Scanning Tips and Considerations
- Using Smart Card Reader
- Using Fingerprint Scanner
- Using Barcode Reader
- Chapter 7 Accessories
- Appendix A: Product Specifications
- Appendix C: Software Development Kit
- Appendix D OS Image Update
Chapter 1Getting Started
10
CAUTION
Check the battery latch:
Removing the Battery Pack:
1. Power off the PDA. Disconnect any cords connected to the device.
2. Turn the PDA over, back facing up.
3. Locate the Battery Lock Latch and push it to the “Unlocked” position.
4. Locate the Battery Release Slider that is spring-loaded. Pull back and hold.
5. Lift the battery out using the opening on side of battery compartment.
Charging the Battery
Please charge the battery before using the PDA for the first time, charge the battery until the LED
indicator turns solid green. To charge the E500RM8, use a cable or a docking with appropriate power
supply. For more information about the E500RM8 accessories, refer to Chapter 7.
LED Status
Indicator
OFF
E500RM8 is not charging or not properly connected
Solid Red
Charging in progress
Continuously
Flash Red
Indicates low battery status (below 15%*)
*Connect to the power source or the system may shut down
Twice Flash
Red
Not enough power for the device to turn on
**Charge the device until the LED indicator becomes solid red
(Indicates the battery is charged more than 3%)
Solid Green
Charging complete