User's Manual

E430RM4L User Guide

7. Pick and raise the SD card holder up in upright position and then put the SD Card into the

socket.

8. Close the SIM card holder and push it into lock position until there is a click sound.

Battery Installation

Inserting the standard BatteryPack into the device:

1. Disconnect AC adapter and power cord from the device.

2. Turn the device over, back facing up.

3. Locate the Battery Lock Latch and push it to the “Unlocked” position.

4. Locate the Battery Release Slider that is spring-loaded. Pull back and hold.

5. Insert the battery on the connector-pins side first, and then lower the battery into the battery

compartment. Continue to hold the Battery Release Slider before battery is fully inserted.

6. Make sure the battery is completely lowered into the compartment before letting go the Battery

Release Slider. Battery will be flat against the housing once fully inserted.

Reinsert the battery by latching the bottom first (1) and then pushing the

battery pack down (2).

CAUTION

Check the battery latch:

Removing the Battery Pack:

1. Power off the PDA. Disconnect any cords connected to the device.

2. Turn the PDA over, back facing up.

3. Locate the Battery Lock Latch and push it to the “Unlocked” position.

4. Locate the Battery Release Slider that is spring-loaded. Pull back and hold.

5. Lift the battery out using the opening on side of battery compartment.