Quick Start Guide

24
Porty G4 Ultra-Rugged Tablet Quick Start Guide
3.5 RTC Wake up
a. Implement Daimler MCU Control and perform COM Port connect to COM1 then set
RTC enable.
b. Click Get RTC Wake and make sure RTC Wake Status=Enable.
c. Click on the Time Sync and allow time synchronization
d. Click Get Time, confirm the time is synchronized
e. Set Alarm Time in order to set the wake-up time.
f. Allow the system to enter the Sleep / Hibernate / Shut down Mode and after a
specified time to wake up Windy Plus. Click get Event to confirm whether wake up by
RTC.
g. Click Get RTC Table and make sure whether the count and time information are
correct.
h. You can choose Year/Month/Day/Hour/Minute in Alarm Repeat Mode.
3.6 Docking In Wake up
a. Implement Daimler MCU Control and perform COM Port connect to COM1 then set
DC In enable.
b. Click Get Docking In Wake and make sure Docking in Wake Status=Enable。
c. Allow the system to enter the Sleep / Hibernate / Shut down Mode and plug in the
power adapter to wake up the Windy Plus, Click get Event to confirm whether wake
up by DC Power In.
d. Click Get Docking In Table and make sure whether the count and time information are correct
3.7 Docking Out Wake up
a. Implement Daimler MCU Control and perform COM Port connect to COM1 then set
Docking Out enable.
b. Click Get Docking Out Wake and make sure Docking Out Wake Status=Enable.
c. Allow the system to enter the Sleep / Hibernate / Shut down Mode and unplug the
power adapter to wake up the Windy Plus. Click get Event to confirm whether wake
up by DC Power Out.
d. Click Get Docking Out Table and make sure whether the count and time information are correct.