Quick Start Guide
Table Of Contents
- Contents
- Chapter 1: Read Me First
- Chapter 2: Getting Started
- 2.1 Overview
- 2.2 Introduction
- 2.3 Product Features
- 2.4 Unpacking
- 2.5 Description of Parts
- 2.6 HotKey for Specific Functions
- 2.7 LED Indicators
- 2.8 First-time Operation
- 2.9 Installing Battery Pack
- 2.10 Installing Micro SD Card
- 2.11 Installing Micro SIM-Card
- 2.12 Connecting to Power Supply
- 2.13 Powering On and Off
- Chapter 3: First Time Operation
- Appendix A: Technical Specifications
Chapter 3: First Time Operation
25
3.8 G-Sensor Wake up
a. Implement Daimler MCU Control and perform COM Port connect to COM1 then set G-Sensor enable.
b. Click Get G-Sensor Wake and make sure G-Sensor Status =Enable。
c. Click on the G-Sensor lnt to adjust the sensitivity of G-Sensor (10 to 0).
d. Allow the system to enter the Sleep / Hibernate / Shut down Mode and motion the
Windy Plus to wake up it. Click get Event to confirm whether wake up by G-Sensor.
e. Click Get G-Sensor Table and make sure whether the count and time information are
correct.