User's Manual

6
Stand-alone Access Point Installation
Follow the instructions below to establish the connection to the Access Point.
A. Connect one end of the Ethernet Cable into the main LAN Port (PoE) of the Access
Point and the other end to the AP Ethernet Port.
B. Connect the Power Adapter to the DC-IN port of the PoE injector and plug the other
end into an electric outlet.
C. Connect the second Ethernet cable into the LAN port of the PoE injector and the other
end to the Ethernet port on the computer.
D. Screw on the provided antennas to the device as shown on the illustration below.
IMPORTANT:
The Access Point supports both IEEE 802.3at PoE (Power over Ethernet) and
the included power injector. You may use either one as the power source.
Do NOT use both at the same time.