Owner`s manual

2-28
SECTION 2
DRIVING YOUR MOTOR HOME
• Do not open any of the four large T-handled
valves on the opposite end of the pump.
These regulate the coach leveling jacks.
Step 2A - Attach Winch and Crank Room
Inward (Models 32T, 34H & 39W with
Standard Riser Slideouts)
• Remove the winch from its storage area in
storage comparment to the rear of the en-
trance door.
• Remove the heating registor from the floor (2
screws) and place the winch base into the
floor duct as shown.
• Attach the hook end of the winch belt through
the looped end of seat belt material fastened
to the floor of the slideout room.
• Be sure the winch ratchet pawl is in the lock-
ing position (against the gear teeth) before
cranking.
Crank the winch handle clockwise slowly, a
few “clicks” at a time, until the room is fully
retracted. Allow about 10 minutes to crank
room in fully.
NOTE: Attempting to crank the room in too
quickly will raise pressure in the hydrau-
lic fluid lines and make cranking more
difficult.
• Leave the winch and strap in place while
driving until slideout is serviced.
Step 3 - Prep for Travel
• Fasten both slideout room travel straps.
Leave the hydraulic pump valve nuts
loosened while winch and strap are connect-
ed.
NOTE: Overtightening the valve nuts may cause
internal damage to the valves.
• See an authorized Winnebago Industries
dealer for service of the room extension sys-
tem before using again.
Use provided 1/4” nut driver to turn nut
counterclockwise 4 turns only.
Slideout Room Solenoid Valve
Leveling Jack Valves - Do Not Open