Owner`s manual

2-29
SECTION 2
DRIVING YOUR MOTOR HOME
Step 2B - (For Models 36G & 39K with Flat
Floor Slideout)
• A wheel (lug) nut wrench is used to crank the
room inward. You may use the wrench sup-
plied wth the coach (in one of the storage
compartments) or any type of lug wrench of
the same nut size.
• Crank-in bolts are located on the outboard
mounting plates of the slideout room as
shown. These plates are located at both ends
of the room inside the StoreMore
TM
compart-
ment doors.
• Remove the locking pin from the crank-in
bolt shafts as shown before trying to turn the
bolts.
• After removing the pin locks, fit the lug
wrench socket onto the bolt head and begin
cranking clockwise slowly a few turns, then
alternate to the other side for a few turns. This
can be sped up by using a helper and an addi-
tional lug wrench to crank both sides evenly
together.
Crank the tire winch clockwise slowly, until
the room is fully retracted. Allow about 10
minutes to crank room in fully.
NOTE: Attempting to crank the room in too
quickly will raise pressure in the hydrau-
lic fluid lines and make cranking more
difficult.
Step 3 - Secure Travel Straps and Close
Hydraulic Line Valves
• Fasten the slideout room Travel Straps as
shown.
• Close the slideout solenoid valves complete-
ly.
NOTE: Close the valves snugly, but do not over-
tighten. Overtightening may cause inter-
nal damage to the valves.
• See your dealer for service of the room exten-
sion system before using again.
Bedroom Slideout Emergency
Retraction
In the unlikely event that your bedroom slide-
out fails to retract using the power switch, check
for obvious causes first, such as low charge on
the house batteries, or a burned out fuse on the
chassis fuse block. (See “Troubleshooting” on
page 2-24.)
NOTE: Check fuses #16 Step Alarm and #24 Ra-
dio/Acc. There is also a fuse on the back
of the HWH leveling system control pad,
which must be unfastened from the driver
door to inspect.