Dash Cam 2.4G Module Model:BT530024 Product Specification WLAN 11b/g/n SDIO MODULE Version: 2.
Contents Contents .............................................................................................................................................................1 1:General Description.........................................................................................................................................
1. General Description IC-‐8189RM product Accord with FCC CE and is 150 wireless SDIO adapter which has lower power consumption, high linearity output power, accords with IEEE802.11B/G/N, and supports IEEE802.11i safety protocol, along with IEEE 802.11e standard service quality.
Host Interface Complies with SDIO 1.1/ 2.0/ 3.0; GSPI interface Standards Supported ■IEEE 802.11b/g/n compatible WLAN ■IEEE 802.11e QoS Enhancement (WMM) ■802.11i (WPA, WPA2).
4. DC Characteristics Symbol VD33A, VD33D VD12A, VD12D VD15A, VD15D IDD33 Parameter 3.3V I/O Supply Voltage 1.2V Core Supply Voltage 1.5V Supply Voltage 3.3V Rating Current Minimum 3.135 Typical 3.3 Maximum 3.465 Units v 1.10 1.2 1.32 v 1.425 1.5 1.575 v -‐ -‐ 600 mA 5.
6. DC/RF characteristics Terms Contents Specification : IEEE802.11b Mode DSSS / CCK Frequency 2412 – 2484MHz Data rate 1, 2, 5.5, 11Mbps DC Characteristics min Typ. max. unit TX mode 305 309 311 mA Rx mode 175 180 181 mA Standby mode 140 145 146 uA Specification : IEEE802.
7.The block diagram of product principle 8.The supported platform Operating System CPU Framework Driver WIN2000/XP/VISTA/WIN7 X86 Platform Enable LINUX2.4/2.6 ARM, MIPSII Enable WINCE5.0/6.
9.
11: The 6th Pin connect to antenna, please refer to design demand Connect to the 9th pin of Module Connect to the 8th pin of Module a) The current of 3.3V power supply must be >300mA, its ripple wave must be <30mV.
13.
FCC Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
ISED Statement: This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: 1.This device may not cause interference. 2.This device must accept any interference, including interference that may cause undesired operation of the device. This equipment should be installed and operated with a minumum distance of 20 cm between the radiator and your body.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables auxappareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1)l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter toutbrouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre lefonctionnement.