User's Manual

13
Maintenance:
CLEANING INSTRUCTIONS: When cleaning, make sure you have unplugged the lighting
xture and allow to it cool to room temperature. Do not open the retaining clips when
cleaning. The lighting xture can be cleaned with a feather duster or a soft damp cloth.
You should plug in the lighting xture after it has been completely dried.
Troubleshooting:
Malfunction Cause Remedy
The light is
not working
The light is under calibration
Wait for 30 seconds until calibration is
nished
Wrong light control setting selected Adjust setting
Main switch is OFF Switch on the Main switch
The light is
always ON
Continuous movement
in the detection zone
Check Switch 1 & 2 settings
The light is ON
without any
identiable movement
Movement occurred, but not identied by the
sensor (movement behind wall, movement of a
small object in immediate lamp vicinity, etc.)
Check Switch 1 & 2 settings
The light is not ON
despite movement
Rapid movements are being suppressed
to minimize malfunctioning of light or the
detection zone you have set is too small
Check Switch 1 & 2 settings
Other accessories:
The lighting xture is provided with a plastic cap and a cable bushing. Always refer to a
qualied electrician if re-wiring of power cable is required. After re-wiring, plastic cap
is used for covering the original opening for power cable, and the cable bushing is used
for output of power cable / hardwire.