User's Manual

2
Important safety instructions:
This product is splash proof, suitable for use in home, oce, warehouse, workshop,
garage and covered wet locations (e.g. covered patios, covered porches, etc.). It is IP65
rated, which means it is protected against dust ingress and is able to withstand splashed
water from any direction (does not include being fully submersed in water or deep
snow). This product is ideal for lighting in wet areas, such as patio awnings and covered
decks. it is also dust and wind proof.
This light is operated by a Smart Sensor Control. It will automatically switch on when
motion is detected and will turn o automatically when there is no movement in area
for preset time.
Please read the following safety information before use.
To reduce risk of re, electric shock, or injury to persons:
Grounded lights must be plugged into an outlet properly installed and grounded in
accordance with all codes and ordinances.
Improperly connecting the grounding wire can result in the risk of electric shock. Do not
modify the power cord plug provided with the product. Never remove the grounding
prong from the plug .
Do not use the light if the power cord or plug is damaged. If damaged, have it repaired
by a service facility before use. If the plug does not t the outlet, have a proper outlet
installed by a qualied electrician.
Disconnect the power cord plug from the power source before making any adjustment
or changing accessories. Do not attempt to install product while plugged in.
Do not abuse the power cord. Never use the power cord to carry the light or pull the plug
from an outlet. Keep the power cord away from heat, oil, sharp edges, or moving parts.
Always refer to a qualied electrician to remove the diuser cover. Unplug and allow to
cool before changing the control setting.
Store the product out of reach of children.
Only use product in its intended location.
Some metal parts in the product may have sharp edges. To prevent cuts, wear gloves
when handling these parts.
Warning:
LED light output is strong enough to injure human eyes. Precautions must be taken
to prevent looking directly at the LEDs without installing the diuser (cover) for
more than a few seconds.
If the lighting xture is damaged, it shall be exclusively replaced by the
manufacturer or the service agent or qualied person in order to avoid a hazard.
The warnings, precautions, and instructions discussed in this manual cannot cover
all possible conditions and situations that may occur. The operator must understand
that common sense and caution are factors which cannot be built into this product,
but must be supplied by the operator.