User's Manual
9
Denition of the each DIP switch control Setting:
Switches 1 & 2: Sensor Detection Distance
Sensor Detection Distance is the detection area of the smart sensor. You can set the
distance from 3 m / 9.8 ft, 5 m / 16.4 ft, 8 m / 26.2 ft, or 10 m / 33 ft. You may refer to the
table below for the height of installation based on 10M setting.
Any movement inside the detection zone
will be detected by the motion sensor.
Actual sensing distance may be inuenced
by environment conditions.
NOTE: The detection distance is measured for a person approximately 1.7 m / 5.6 ft tall,
moving at a speed of 1.0 - 1.5 m/sec (3.2 - 5 ft/sec).
You may select 3 m / 9.8 ft or 5 m / 16.4 ft for a small area, and select a 8 m / 26.2 ft or
10 m / 33 ft for a larger area.
Switches 3 & 4: Time Dim
Time Dim is the time to dim the lighting xture when no movement detected. You can
set Time Dim from O, 30 seconds, 5 minutes, or 10 minutes. The lighting xture will
be dimmed if there is no movement detected by the sensor. Any movement detected
within this period will restart the timer, and the time will be counted again.
You may select 10 min for use in garage, or a shorter time such as 5 min for use in
covered patio. You may disable the Time Dim function by selecting OFF.
Height (H) Sensing Distance (D)
2.5 m / 8.2 ft 7 m / 23 ft - 8 m / 26.2 ft
3.0 m / 9.8 ft 8 m / 26.2 ft - 10 m / 32.8 ft
120º