Specification LM57176 LED CEILING LIGHT WITH AMBIANCE GLOW Specification File name: Product specification V1.0 Version: File status: [ ] Draft [√ ] Published [ ] Pending Editor: Finished date: Version V1.
Specification 0 Amendment 1 Feature ⚫ LM57176 CS-CRD02-XX1 HD021VCRmicrowave module, which applies ⚫ microwave chip, can colasmart self-R&DCS3921 effectively sense human and entity motion Light sensor is available when correspondent component is extra-connected IR remote is available when correspondent component is extra-connected ,and microwave motion sensor distance,hold time,lux threshold etc can be adjusted by IR remote Plate-antenna applied for the sake of max long-distance detection purpose RGB ba
Specification 4 Drawing IR Receiver Red : VCC Black :GND White :PWM Mechanical structure(mm)
Specification Brightness level Level 1st level Pwm % Level 2nd level 3th level 4th level 10% 20% 30% 40% Min Max 10% 100% 9 level 10 level Pwm % th th 90% 100% 5th level 6th level 7th level 8th level 50% 60% 70% 80% 5.6 Hold time Hold time level 1min 5min 10min 30min Time to dim to stand-by brightness from current brightness(half of current brightness) 30s 4min 9min 29min Time to dim to OFF from stand-by brightness(half of current brightness) 30s 1min 1min 1min 5.
Specification FCC Information This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS OR CHANGE TO THIS EQUIPMENT.
one tested. Specification IC Information -English: 1. This device complies with Industry Canada RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.