User Manual

JDY-25M Super BLE Bluetooth Module

Default：0

AT+SUBTYPE +SUBTYPE=<Para

Note: After the SUBTYPE is set to 1, the level of the remote device controlled by the INPUT key will change as

the level of its OUTPUT pin.

For example, INPUT1 controls the remote device INPUT1 level to high level, and its own INPUT1 pin will

also become high level.

42、Set/query - Learn switch enable

Instruction Response Parameter

AT+LEARN<Param> +OK Param：1 or 0

1：Button and output pin learn mode on

0：Button and output pin learn mode off

Default：0

AT+LEARN +LEARN=<Para

Note: When LEARN is set to 1, it means the parameters of INPUT pin set by AT+KEY are completely invalid. The

parameters of key sending and receiving will be acquired by AT+LEAVAL or key learning.

For key learning configuration, please refer to the document Switch panel instructions. PDF.

43、Set/query - Learn parameter

Instruction Response Parameter

AT+LEAVAL

+OK P1：OUTPUT pin number of current

device

P2：Code sender INPUT pin number

P3：Code sender short address

（0001-FF00）

Default：0,0,0000

AT+LEAVAL +LEAVAL=

When LEARN mode is on, AT+LEAVAL instruction configures parameters.

Example 1: Remote 0008 device KEY1 simultaneously controls the current device's OUTPUT1 and OUTPUT2

levels

Current device sends instruction: AT+LEAVAL1,1,0008 send AT+LEAVAL2,1,154A

Example 2: Remote 0008 device KEY2 controls the current device's OUTPUT5 level

Current device sends instruction: AT+LEAVAL5,2,0008

44、Set/query - Turn on one key binding to connect the strongest signal slave

Instruction Response Parameter