User Manual

FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
The Video Light APP Module is designed to comply with the FCC statement. FCC ID is WUI-PYBLE50. The
host system using Video Light APP Module, should have label indicated it contain modular’s FCC ID:WUI-
PYBLE50 . This radio module must not installed to colocate and operating simultaneously with other radios
in host system additional testing and equipment authorization may be required to operating simultaneously
with other radio.
The Video Light APP Module Module and its antenna must not be co-located or operating in conjunction with
any other transmitter or antenna within a host device.
The modular must be installed in the host that assign by Company name: Winplus Co., Ltd. Product/PMN:
Video Light APP Module Model no./HVIN: JDY-25M if other host types used would need further evaluation and
possible C2PC if they are not significantly similar to the one tested
Notice to OEM integrator
The end user manual shall include all required regulatory information/warning as show in this manual. The
OEM integrator is responsible for testing their end-product for any additional compliance requirements
required with this module installed. If the final product contains circuits of other FCC PART 15 Subparts,the
final host product still requires Part 15 Subpart B compliance testing with the modular transmitter installed
The intended use is generally not for the general public.lt is generally for industry/commercial use. The
connector is within the transmitter enclosure and can only be accessed by disassembly of the transmitter that is
not nomally required, the user has no access to the connector.Installation must be controlled. Installation
requires special training.
This device complies with Part 15, Part 15.247 of the FCC Rules.
RF warning for portable device:
The device has been evaluated to meet general RF exposure requirement. The devicecan be used in portable
exposure condition without restriction.