Specifications

• There are “L” & “R” labels on wiring harness, please

connect sensor to corresponding connector

• Please conrm the sensor “UP” side faces upward and

the installation height is high enough

• Please make sure that the wiring harness is xed well and

far away from vent-pipe

• Please remove burrs and ash from the hole, make the

hole t for sensor, not too tight or loose, otherwise the

system should be abnormal

• The connector of the control box should face ground to

prevent water

• Clip the two warning LEDs into the plastic weatherstrips

on the A pillar

LED Display

distance in meter

left sideright side

Operations

NOTE: If the unit is installed as outlined, it should ONLY

function when the Left and Right turn signals are activated:

Activate/Deactivate Left Sensors:

• To Activate turn your left turn signal On

• The unit will beep

• The Left LED Warning lights will blink when there is an

obstacle on the vehicle’s left blind spot.

• The display will show the distance of the obstacle from

the left blind spot sensor

• To deactivate turn your left turn signal Off

Activate/Deactivate Right Sensors:

• To Activate turn your right turn signal On

• The unit will beep

• The Right LED Warning lights will blink when there is an

obstacle on the vehicle’s right blind spot.

• The display will show the distance of the obstacle from

the right blind spot sensor

• To deactivate turn your right turn signal Off

WARNING: Do not solely rely on the Blind Spot Assist

System. Always practice safe driving habit. Always do a

visual check of your vehicle’s surrounding before turning or

switching lanes.