Installation Guide

ManualsBrandsWINSOON ManualsBarn Door Hardware16 ft./192 in. Stainless Steel Sliding Spoke Wheel Barn Door Hardware Kit for Double Door with Non-Routed Floor Guide

www.winsoonhardware.com

Installation Manual

• Failure to wear proper safety gear (i.e.,eye protection) may result in serious

injury or death. Always wear proper safety gear before using power tools.

• Improper operation of power tools may result in loss of control, serious injury or

death. Always ensure you have complete control of the power tool and the work

area is free of hazards before operatiog a power tool.

• Lack of secure clamping of the door may result in unexpected movement of the

door,loss of power tool control and serious injury or death. Always securely clamp

the door in place before cutting,or drilling, the door.

• Lack of ,or improperly installed Anti-jump Disc may result in the door coming

off the track and cause serious injury or death. installation of Anti-jump Disks are

required for safe operation of this hardware. installed properly, these discs will keep

the door securely attached to the teack.

WARNING

• Mishandling of heavy objects (i.e.,doors) may cause a loss of balance and serious

injury. Always be sure you have a secure hold on the object and are balanced before

moving the object.Always wear safety shoes when lifting heavy objects.

• Getting body parts (i.e., hair,fingers) caught in moving parts may cause pinching

and serious injury.Do not put fingers in parts that may move and always remove or

contain anything on your body that may become entangled with a moving part.

• Closing sliding doors with your hand on the end of the door may result in your

hand, or fingers, getting caught between the door and other solid objects (i.e.,

another door, molding) causing serious injury. Always use the door handle to close

doors.

CAUTION

Usage Statement:

Use of excessive force when opening, and closing,the door(s) may result in damage to the

hardware. Always hold the handle and gently open and close the door(s).

5 year straight unconditional warranty service enables every single hardware’s durability

coverage during its life time.

Warranty Statement:

Summary of content (4 pages)

PAGE 1
WARNING • Failure to wear proper safety gear (i.e.,eye protection) may result in serious injury or death. Always wear proper safety gear before using power tools. • Improper operation of power tools may result in loss of control, serious injury or death. Always ensure you have complete control of the power tool and the work area is free of hazards before operatiog a power tool.
PAGE 2
54mm/2.13in 16mm/0.63in 98mm/3.86in 83mm/3.27in 8mm/0.32in 54mm/2.13in 50mm/1.97in 70mm/2.761in 30mm/1.18in 12mm/0.48in 50mm/1.97in 70mm/2.76in 30mm/1.18in type-b type-c Hanger Part Name picture 1 6FT 6.6FT 7.
PAGE 3
10.3” 19.7” 19.7” Step-a 10.3” 5FT 2.28”/58 mm 9/32” 6.45” 19.7” 19.7” 19.7” 6.45” 6FT Door Height 10.05” 19.7” 19.7” 19.7” 10.05” 6.6FT 0.4”/10mm 3/8” 5.6” 19.7” 19.7” 19.7” 19.7” 1. Draw down a horizontal line which is [2-5/16 (58mm) + Door Height + 3/8”(10mm)] above the floor. The length of the line needs to be the same as your total track length. 2. The horizontal line is to label out the track’s center line, and mark down each track holes’ center point to attach the track later.
PAGE 4
Step-d Step-g 1. Put the door on the track, adjust the distance of the Anti jump device to avoid the door falling off the track. 1. Overlapping b - 1 and b - 2 and tighten to fix the rails to the wall B-1 B-2 2. Now you have installed the track on the wall successfully. Anti jump device 2. Adjusting the position of the stopper and fix it with a hex wrench. 3. press the plug on. Step-h Step-e 1. Open a slot ( 0.79”/20mm wide,0.79”/20mm deep ) at the bottom of the door with a chainsaw.