Installation Guide

5
www.winsoonhardware.com
www.winsoonhardware.com
2
b-2
b-3
Door
Height
2.28”/58 mm
9/32”
0.4”/10mm
3/8”
Step-a
Step-b
Step-c
1Putting the b-3 into the rail and make the hole
direction of b-3, rail and b-2 is consistent.
2. Installing in order from inside to outside to
prevent missing the hole
1.Mark the positions of each set’s two spacer
holes, the distance between each hole is shown
as the picture.
2.Punch all the marked positions into the wall
with impact drill, put the expansion pipes into
the holes created, then punch the pipe pins into
the wall until the expansion pipes expand at
their ends, screw b - 1 into the expansion pipe.
1. Draw down a horizontal line which is [2-5/16
(58mm) + Door Height + 3/8”(10mm)] above
the floor. The length of the line needs to be the
same as your total track length.
2. The horizontal line is to label out the track’s
center line, and mark down each track holes’
center point to attach the track later.
b-1
b-1
b-2
b-3
18.59in
18.59in
18.59in
1.1in
1.1in
1.1in
1.1in
1-1/9”
28mm/1.1in
First Hole
19.7” 19.7” 10.3”10.3”
5FT
19.7” 19.7” 10.3”10.3”
19.7” 19.7” 10.3”10.3”
16FT
19.7” 19.7” 19.7” 6.45”6.45”
19.7” 19.7” 19.7” 6.45”6.45”
6FT
19.7” 19.7” 19.7” 10.05”10.05”
6.6FT
19.7” 19.7” 19.7” 19.7” 5.6”5.6”
7.5FT
19.7” 19.7” 19.7” 19.7” 5.6”5.6” 19.7” 19.7” 19.7” 19.7” 5.6”5.6”
15FT
19.7” 19.7” 19.7” 19.7” 8.6”8.6”
8FT
10FT
19.7” 19.7” 10.3”10.3” 19.7” 19.7” 10.3”10.3”
12FT
19.7” 19.7” 19.7” 6.45”6.45” 19.7” 19.7” 19.7” 6.45”6.45”
13FT
19.7” 19.7” 19.7” 10.05”10.05” 19.7” 19.7” 19.7” 10.05”10.05”