Manualshelf

Instructions / Assembly

ManualsBrandsWINSOON ManualsBarn Door Hardware6.6 ft./79 in. Powder Coated Black Heavy-Duty Bypass Double Door Sliding Barn Door Hardware Classic Design Roller
12345678910
3
Step 2: Cut Floor Guide Slot At The Bottom Of The Door
①If you use type A floor guide , you will need to
Cut a 5/16” (7mm) wide, 3/4” (20mm) deep slot at the bottom of the
door.
Recommended: Cut the slot with a router and slot cutter
bit.
②If you use type B floor guide , please skip this
step.
5/16”(7mm)
3/4”(20mm)
Step 3: Install anti-jump pad
As shown in the illustration, the screw is near the front
edge of your door (recommended: drill pilot hole to avoid splitting).
Do not over tighten.