Instructions / Assembly

4
Prepare and Install the Tracks
Step 4: Draw 3 Lines for the Track and Brackets
a.Using a level, draw line ① for the Track, at the door
height + 1-11/16” (43mm) above the floor.
b.Pencil lines ② and ③ for the Bracket above line ① as
shown in the illustrations below.
①
②
③
Door Height+1-11/16”(43mm)
2-9/16”(65mm)
1-3/8”(35mm)
Step 5: Mark and Drill Track Holes
a.Line up a Track on lowest line and mark the location of the
holes.
b.Use level to mark the hole locations directly above the
original marks on the upper two lines. (Tip: Take care to make the
upper two marks parallel to each other so Hangers hang straight.)
c.Concrete wall: Drill holes by using a 3/8” (10mm) concrete
drill bit.
d.Wood framed wall: Drill out the holes by using a drill with
1/4” (6mm) drill bit.