Manualshelf

Instructions / Assembly

ManualsBrandsWINSOON ManualsBarn Door Hardware7.5 ft./90 in. Black Sliding Bypass Barn Door Hardware Track Kit for Double Doors with Non-Routed Floor Guide
12345678910
5/16”(7mm)
3/4”(20mm)
3
Step 2: Cut Floor Guide Slot At The Bottom Of The Door
①If you use type A floor guide , you will need to cut
a 5/16” (7mm) wide, 3/4” (20mm) deep slot at the bottom of the door.
Recommended: Cut the slot with a router and slot cutter bit.
②
If you use type B floor guide , please skip this step.
Step 3: Install anti-jump pad
As shown in the illustration, the screw is near the front
edge of your door (recommended: drill pilot hole to avoid splitting).
Do not over tighten.