Instructions / Assembly

Step 6: Mark and Drill Track Holes

a.Line up a Track on lowest line and mark the location of the

holes.

b.Use level to mark the hole locations directly above the

original marks on the upper two lines. (Tip: Take care to make the

upper two marks parallel to each other so Hangers hang straight.)

c.Concrete wall: Drill holes by using a 3/8” (10mm) concrete

drill bit.

d.Wood framed wall: Drill out the holes by using a drill with

1/4” (6mm) drill bit.

Step 7: Install The Inside Track

Using the Spacers, Long Lag Screws, and Washers (and

hollow wall anchor if necessary), attach the Inside Track to the wall

as shown in the illustration below.

Tip: Loosely attach one end of the Track with the other end

resting on the ground. Then swing track up and attach other end.

Finally, fill in the middle holes.

Concrete wall

Wooden wall

4”（100mm）