Instructions / Assembly

Step 5: Install The Inside Track

Using the Spacers, Long Lag Screws, and Washers (and hollow wall anchor if nec-

essary), attach the Track to the wall as shown in the illustration below.

Tip: Loosely attach one end of the Track with the other end resting on the ground.

Then swing track up and attach other end. Finally, fill in the middle holes.

Concrete wall

Wooden wall

②Spacer

②

①hollow wall anchor

①

③Washers

③

④

③

②

Step 7: Attach Brackets to the Wall

a.Loosely attach each bracket to the wall with Short Lag Screws and washers (and

hollow wall anchors if needed).

b.Fully tighten all Lag Screws with your ratchet. Don’t overtighten screws as you may

strip the studs or anchors.

①hollow wall anchor

②Washers

③2-9/16” Lag Screws

④4” Lag Screws

①

③

②

Door Height+1-11/16”

Step 5: Mark and Drill Track Holes

a.Line up a Track on lowest line and mark the location of the holes. Note: holes are

16” apart, line up with wall studs if possible.

b.Use level to mark the hole locations directly above the original marks on the upper

two lines. (Tip: Take care to make the upper two marks parallel to each other so Hangers

hang straight.)

c.Concrete wall: Drill holes by using a 3/8” concrete drill bit.

d.Wood framed wall: Drill out the holes by using a drill with 1/4”drill bit.