Instructions / Assembly

ManualsBrandsWINSOON ManualsBarn Door Hardware9 ft./108 in. Black Sliding Bypass Barn Door Hardware Track Kit for Double Doors with Non-Routed Floor Guide

Prepare Your Doors

※Hardware Installation

Step 1: Attach Steel Hangers to Your Doors

a.Drill 7/16”holes at the distances from the top of the doors shown in the above

chart.Note: The Hanger Bolts are inserted through the back of the door (i.e. the Hanger

and Acorn Nuts attach to the front face of the door).

.Attach Hangers with the Hanger Bolts, Washers and Acorn Nuts as shown below.

1-9/16”

3-9/16”

※Chart: Track Junction

Installation Manual

Barn Door Hardware

www.winsoonhardware.com

● Installation Tools

Pencil Level RatchetWrenchRuler

Drill

Router

※Check the Quantities

Note: If you encounter any problem with the package and the following installation,

please email us at info@winsoonhardware.com. Please also tell us your “ORDER

ID,” we will solve any issues for you as soon as possible.

Steel

Hanger

Door

Stopper

Anti-jump

Pad

Junction

Plate

Double Door Hardware Kit Includes

Part Name Flat Track

picture

Lag Bolt

Spacer

9FT

44 24

6 6 6

Floor

guide

Bypass

Bracket Suit

1-3/4in

8” 16”

16”

14”

9FT

16” 16” 8”14”

Summary of content (5 pages)

PAGE 1
www.winsoonhardware.com Barn Door Hardware Installation Manual ※Check the Quantities Note: If you encounter any problem with the package and the following installation, please email us at info@winsoonhardware.com. Please also tell us your “ORDER ID,” we will solve any issues for you as soon as possible.
PAGE 2
Step 2: Install anti-jump pad As shown in the illustration, the screw is near the front edge of your door (recommended: drill pilot hole to avoid splitting). Do not over tighten. Prepare and Install the Tracks Step 3: Connect Tracks And Install Door Stoppers a.Connect your tracks with junction plates. b.Loosely install the Door Stoppers near each end of the track (final positioning will be determined at the end of the installation (Step 10)). Step 4: Draw 3 Lines for the Track and Brackets a.
PAGE 3
Step 5: Mark and Drill Track Holes a.Line up a Track on lowest line and mark the location of the holes. Note: holes are 16” apart, line up with wall studs if possible. b.Use level to mark the hole locations directly above the original marks on the upper two lines. (Tip: Take care to make the upper two marks parallel to each other so Hangers hang straight.) c.Concrete wall: Drill holes by using a 3/8” concrete drill bit. d.Wood framed wall: Drill out the holes by using a drill with 1/4”drill bit.
PAGE 4
Step 8: Install the Outside Track Using the spacers, Track Bolts, Washers and Nuts attach the outside Track to the Bypass Bracket as shown in the illustrations below. ①Nuts ②Spacer ③Washers ④track bolt ④③ ① ② Hanging and Positioning Doors Step 9: Install Your Doors Lift and hang your doors on the Track, and then twist the Anti-Jump Pad toward the wall so that it is under the Track.
PAGE 5
Step 10: Install the Floor Guide a.Position the door at your desired open position, put half of the floor guide under the door, mark the location, and then fix guide to the floor. b.Position doors in your desired open and closed position and adjust Door Stoppers. Inside Door Outside Door WARNING • Failure to wear proper safety gear (i.e.,eye protection) may result in serious injury or death. Always wear proper safety gear before using power tools.