Barn Door Hardware Installation Manual www.winsoonhardware.
Track Accessories Single Door Hardware Kit Includes Type A Type B Part Name Flat Track Steel Hanger Anti-jump Floor guide Floor guide Door Stopper Lag Bolt Pad Spacer Junction Plate picture 4FT 1 2 2 1 1 2 3 3 0 ① Check the quantity of all the accessories. ② Any product problems or installation questions, please email us at prductservicecenter@outlook.com with your “order ID”.
Step 1: ① Measure the overall height for the center line of the track, make sure it shouldbe door height + [1-11/16 (43mm)] above the floor. ② Mark out all the holes’position according to your track. 16” door height + 1-11/16” (43mm) 16” Step 2: Drill holes and install your track ①Concrete wall: Drill out the holes by using a dril with 3/8” (10mm)drill bit. ②Wooden wall: Drill out the holes by using a drill with 1/4” (6mm) drill bit. ③Install the track refer to the below image.
Step 3: ①If you use type A floor guide , you will need to open a slot [5/16” (7mm) wide, 3/4” (20mm) deep] at the bottom of the door with a slotting machine. ②If you use type B floor guide , please skip this step. 5/1 6” (7m m) 3/4 ”( 20 mm ) Step 4: Install hangers on your door.
Step 5: Install anti-jump pad. As the picture shows, the screw is near the edge of your door. Step 6: Put your hangers on the track, then twist the anti-jump pad facing to your wall.
Step 7: Install your floor guides.
Step 8: Adjust and fix stoppers to make the door not detach from the floor guide whether the door on close or open position.
WARNING • Failure to wear proper safety gear (i.e.,eye protection) may result in serious injury or death. Always wear proper safety gear before using power tools. • Improper operation of power tools may result in loss of control, serious injury or death. Always ensure you have complete control of the power tool and the work area is free of hazards before operatiog a power tool.