Instructions / Assembly

ManualsBrandsWINSOON ManualsBarn Door Hardware4 ft. /48 in. Frosted Black Sliding Barn Door Track and Hardware Kit for Double Doors with Non-Routed Floor Guide

Track Accessories

Steel Hanger

Door Stopper

Anti-jump

Pad

Floor guide

Junction

Plate

Single Door Hardware Kit Includes

Part Name

Flat Track

picture

Lag Bolt

Spacer

4FT

1 2 2 1 2 3 3 0

Chart: Track Junction

16” 16” 8”8”

4FT

Installation Manual

Barn Door Hardware

www.winsoonhardware.com

door hight + 1-11/16” (43mm)

Main Installation Dimension

※Hardware Installation

3/8”(10mm)

1-5/16’’(33mm)

① Check the quantity of all the accessories.

② Any product problems or installation questions, please email us at

prductservicecenter@outlook.com with your “order ID”.

Summary of content (4 pages)

PAGE 1
Track Accessories Single Door Hardware Kit Includes Barn Door Hardware Part Name Flat Track Steel Hanger Anti-jump Pad Floor guide Door Stopper Lag Bolt Spacer Junction Plate 3 3 0 picture Installation Manual 4FT 1 2 2 1 2 ① Check the quantity of all the accessories. ② Any product problems or installation questions, please email us at prductservicecenter@outlook.com with your “order ID”.
PAGE 2
Step 1: ① Measure the overall height for the center line of the track, make sure it shouldbe door height + 1-11/16” (43mm) above the floor. ② Mark out all the holes’ position according to your track. 6” 16” 16” Step 3: Open a slot [5/16” (7mm) wide, 3/4” (20mm) deep] at the bottom of the door with a slotting machine. 8” door height + 1-11/16” (43mm) 5/16”(7mm) 3/4”(20mm) Step 2: Drill holes and install your track ① Concrete wall: Drill out the holes by using a drill with 3/8” (10mm) drill bit.
PAGE 3
Step 7: Close your door, put the floor guide half out of the door, then fix it on the floor. Step 6: Put your hangers on the track, then twist the anti-jump pad facing to your wall. Step 8: Adjust and fix stoppers to make the door not detach from the floor guide whether the door on close or open position. φ1/4” (6mm) Step 5: Install anti-jump pad. As the picture shows, the screw is near the edge of your door.
PAGE 4
WARNING • Failure to wear proper safety gear (i.e.,eye protection) may result in serious injury or death. Always wear proper safety gear before using power tools. • Improper operation of power tools may result in loss of control, serious injury or death. Always ensure you have complete control of the power tool and the work area is free of hazards before operatiog a power tool.