Barn Door Hardware Installation Manual www.winsoonhardware.
Track Accessories Single Door Hardware Kit Includes Part Name Flat Track Steel Hanger Anti-jump Pad Floor guide Door Stopper Lag Bolt Spacer Junction Plate 3 3 0 picture 4FT 1 2 2 1 2 ① Check the quantity of all the accessories. ② Any product problems or installation questions, please email us at prductservicecenter@outlook.com with your “order ID”.
Step 1: Connect your tracks first with junction plate if needed Step 2: ① Measure the overall height for the center line of the track, make sure it shouldbe door height + [1-11/16 (43mm)] above the floor. ② Mark out all the holes’position according to your track.
Step 3: Drill holes and install your track ①Concrete wall: Drill out the holes by using a dril with 3/8” (10mm)drill bit. ②Wooden wall: Drill out the holes by using a drill with 1/4” (6mm) drill bit. ③Install the track refer to the below image. Concrete wall Wooden wall Step 4: Open a slot [5/16” (7mm) wide, 3/4” (20mm) deep] at the bottom of the door with a slotting machine.
Step 5: Install hangers on your door. 1-5/16“ (33mm) 3-9/16” (90mm) φ3/8” (10mm) ” /16 5 3-1 mm ~ ” 00 /8 ) 2-3 mm-1 end 60 comm (re Step 6: Install anti-jump pad. As the picture shows, the screw is near the edge of your door.
Step 7: Put your hangers on the track, then twist the anti-jump pad facing to your wall. Step 8: Close your door, put the floor guide half out of the door, then fix it on the floor.
Step 9: Adjust and fix stoppers to make the door not detach from the floor guide whether the door on close or open position.
WARNING • Failure to wear proper safety gear (i.e.,eye protection) may result in serious injury or death. Always wear proper safety gear before using power tools. • Improper operation of power tools may result in loss of control, serious injury or death. Always ensure you have complete control of the power tool and the work area is free of hazards before operatiog a power tool.
