Instructions / Assembly

3
Step 3: Connect Tracks And Install Door Stoppers
a.Connect your tracks with junction plates if needed.
b.Loosely install the Door Stoppers near each end of the track (final positioning will
be determined at the end of the installation (Step 9)).
Prepare and Install the Tracks
Step 4:Draw Line for the Track
Using a level, draw a line for the Track, at the door height + 1-11/16” above the
floor.
door height + 1-11/16”
Step 2: Install anti-jump pad
a.The inside door should install the round anti-jump pads very close to the hanger
as shown in the picture.The screw is near the front edge of your door (recommended:
drill pilot hole to avoid splitting). Do not over tighten.
b.The outside door has the spceial anti-jump pads. you could adjust it with the tools.