Assembly Instructions

Drain
Hole
Drain
Hole
Table Assembly Instructions for
Round KD (Knock Down) Base Only & Alternative Top
NOTE- Table design is for illustrative purposes only. Your actual table
design might look dierent.
IMPORTANT: Two people are recommended to eectively and safely
assemble this table due to the size and weight of the product.
Tools required for assembly: 7/16” wrench or adjustable wrench
Refer to illustration.
1. Place Table TOP (A) upside down on a clean, level surface that will not
mar or potentially scratch the top side of the top.
2. Using a 1 ¼” hex head bolt (D) and washer (E), attach the inner ring
(B) to table leg (C). NOTE- make sure the drain holes on the inner
ring (B) are facing up for assembly. The attaching point of the legs
(C) to the inner ring (B) is designed to “lock” together. Hand tighten
loosely. Repeat this step for the remaining three legs.
3. Place loosely assembled table base onto the table top and align holes
on legs with holes in the underside of the top. Using a ¾” hex head
bolt and washer, screw the legs to the top. Very loosely hand tighten
the two bolts per leg until all four legs are attached to the top.
4. Hand tighten all connections then securely tighten with wrench.
Turn table right side up and enjoy!
Safety First:
• Anumbrellabasemustbeusedwithanumbrella
• Whenumbrellaisnotinuseorinhighwindorinclementweather,itis
recommended that the umbrella be removed from the table and stored.
• Neverleaveanunattendedumbrellaopen.
• Neversitorstandonthetable
PARTS
DESCRIPTION PICTURE
QTY
DESCRIPTION PICTURE QTY
A Table Top 1 E Flat
Washer
12
B Inner Ring 1 F ¾” Short
Bolt
8
C Table Leg 4 G Umbrella
Hole Plug
(if applicable)
1
D 1 ¼” Long
Bolt
4