User`s manual

User’s Manual
II
RCU Battery
 Batteries should be installed in accordance with the (+/-) markings on battery compartment.
 Remove batteries if RCU not be used for a long time.
 Replace batteries if there is no enough power and dispose battery waste properly for
environmental protection.
Others
 The all-pole power switch of this receiver is on rear panel. Switch it to “I”, related equipment
will connect with power supply. Switch it to “
o”, related equipment will disconnect with
power supply completely.
 Only use accessories specified by the manufacturer, as other unsupported accessories
may cause damage to the receiver.
Symbols on the Receiver
Part 1: Warning Mark
This mark appears on rear panel of this receiver, painted prominently in contrasting color to
background. It consists of two graphical symbols and warning messages. The detailed
specifications are as follows:
Warning: To reduce the risk of electric shock, don’t remove the cover (or
back). Equipment service and maintenance should be undertaken by
qualified personnel.
This symbol alerts user to the presence of uninsulated “dangerous voltage”
in product enclosure that sufficient magnitude will constitute risk to person.
This symbol reminds user of presence of important operation and
maintenance instructions in literature accompanying this receiver.
Part 2: CE Mark
This mark appears on rear panel of this receiver, painted prominently in contrasting color to
background.
This mark tells you that the receiver is following the provisions of Council
Directive 89/336/EEC on the approximation of the laws of the Member
States relating to the electromagnetic compatibility and the provisions of
Council Directive 73/23/EEC and 93/68/EEC on the approximation of the
laws of the Member States relating to low voltage and electrical safety.