User's Manual

6. System Connections
Receiver and servo connections
Non-electric Model
- When you install the system in an non-electric model (or mechanical type speed control), you
should use the battery holder to supply the power for receiver
E.S.C. Installation Model
Connection Precautions
A. Installation Note
- After you installed the system, please check the receiver, servo, and battery connections,
make sure all the connections are fully inserted.
- The package contains the rubber bungs, if the slot is not in using, it can be plugged with the
bung to prevent the water splashing.
- To protect absolutely the system from water or oil damage, you can place it in a plastic bag or
waterproof box.
- Please remember this; always turn your transmitter on first and off last. Failure to do so may
result in loss of control and can damage your servos and/or linkage.