User's Manual

8. Transmitter Operations
A. Antenna
- Please extend the antenna to the full length when you operating, to gain the best radio
performance.
- Be careful to handle the antenna, do not bend it.
B. Power Switch
- Stir the switch right to turn on the transmitter, and left to off it.
- Please note that turn on your transmitter first and then switch on the receiver switch to
prevent accidental runaways.
C. Power Indicator LEDs
- There are 3 LEDs to show the power status.
- Green is full power, amber is mid power and red is low power.
- When red LES is flashing, please replace the battery or charge immediately.
D. Steering Reversing Switch
- According to your model design, change the direction of the servo travel to fit the usage.
- The default position is “NOR”, if you steer right and the wheels go left, change the “ST.”
switch from “NOR” to “REV”.
E. Throttle Reversing Switch
- According to your model design, change the direction of the servo travel to fit the usage.
- You should not need to change the "THR" switch (default is “NOR”) when using an
Electronic Speed Control.
F. Steering Wheel
- Use the steering wheel to control the direction of your model.
A. Antenna
D. Steering Reversing Switch
E. Throttle Reversing Switch
H. Steering Trim
I. Throttle Trim
G.Throttle Trigger
F. Steering Wheel
J. Steering Dual Rate
Holder
C. Power Indicator LEDs
O. Multi-function Switch
P. Neck Strap
Hoo
k
M. Crystal
K. Charger Jack
B. Power Switch
L.Battery Cover
N. 2/3CH Mode Switch