User's Manual

ManualsBrandsWintecronics ManualsAutomotiveCar Alarm System

USER’S MANUAL

LCA2200 ( Long Range Auto Monitor)

FCC Statement

This device complies with part 15 of the FCC Rules. Operation is subject to the following two condition.(1).this device may not cause harmful interference. (2).this

device must accept any interference received, including interference that may cause undesired operation

Warning:

Note: This equipment has been tested and found to comply with the limits for digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This equipment generates, used and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interference in to radiate communications. However, there is no guarantee that interference

will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

l Reorient or relocate the receiving antenna

l Increase the separation between the equipment and receiver.

l Connect the equipment into an outlet on a circuit different form that to which the receiver in connected.

l Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference: and

(2) This device must accept any interference received: including interference that may cause

undesired operation.

THE MANUFACTURER IS NOT RESPONSIBKE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS

EQUIPMENT.SUCH ODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.

Note: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modification to this equipment. Such modification could void the user’s

authority to operate the equipment.

1114

Summary of content (5 pages)

PAGE 1
USER’S MANUAL LCA2200 ( Long Range Auto Monitor) 1114 FCC Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two condition.(1).this device may not cause harmful interference. (2).this device must accept any interference received, including interference that may cause undesired operation Warning: Note: This equipment has been tested and found to comply with the limits for digital device, pursuant to Part 15 of FCC Rules.
PAGE 2
Buttons’ Features: ON/OFF button: Press this button to turn receiver’s power “ ON ”, pressing a few sec will turn the power “ OFF ”。 Audible / Vibration alert button: While power “ON ”; Press and hold this button one sec, a “Bi Bi” is heard to confirm the pager in beep mode without icon. Upon a second press , vibration is felt to confirm the pager in vibration alert mode and will show up。 RESET/ Backlight button: Press this button to have backlight a few sec.
PAGE 3
B Type : In this type , the vehicle has neither remote-controlled central locking system or security system. Ignition switch is used to enable the main control module to operate monitoring “ON” and “Off” functions. C Type : In this type, the vehicle is installed with remote-controlled central locking system. The door lock/unlock output is used to enable the main control module to operate the monitoring ON and Off functions. ※ Note: 1. For A and B types , set the control module to the MODE # 1 . 2.
PAGE 4
the orange wire with key switch ignition position wire but the disadvantage is that the LCD receiver sounds alert when the vehicle door is opened while the system enters into arm mode. 5.Blue wire: When this wire has negative input, the receiver’s LCD will show up “trunk open” icon. Connect this wire with switch trigger wire.
PAGE 5