User's Manual

Step1 open the upper cover
Step 3.Replace upper cover
Abtain the receiver on the cover
1:when you want use the mouse,you can take out the receiver to computer by the
list step;
2:when you need stop the work or to travel, you can store the receiver on the mouse
for the moving by the list step;
1
2
Installing the Batteries
The RF2.4GHz optical mouse use one AA alkaline batteries.
Installing Batteries in the Mouse
Step2. Insert the battery as shown inside the battery compartment.
Connecting the Receiver
USB Port
CAUTION:To use this device properly,please read
the user’s guide before installation
1.Connect the USB piug ONLY to USB port of the computer
Take out the receiver
Store the receiver
Model:WM781
Instruction Manual
RF2.4GHz Optical Mouse
1
2
*This mouse is equipped with Traveling-Power-Save function.
When you are traveling with this mouse, the LED of the mouse will be switched off
automatically for the purpose of power-save, but the pre-condition is that the
receiver is disconnected with your notebook or PC.
*when your mouse no any clik or scroll or moving,the mouse will cme to sleep
state for the economize after about 30 minutes, for the wake up,you can click any
button for this
Power-Save function:
Characteristics
FCC STATEMENT :
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and (2) This device must
accept any interference received, including interference that may cause
undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.