User Manual
Thanks for choosing WINTORY AIR wireless headset. To ensure that you can use this product properly, please read this users’ manual carefully. [Product Introduction] WINTORY AIR is 2.4GHz wireless over-ear headset which supports Windows/IOS and other systems. WINTORY AIR mainly contains an USB dongle (signal projector) and a wireless headset (signal receiver). It also has a 3.5mm LINE-IN audio cable, a detachable mic and a Type-C charging cable.
1. Wireless headset 2. Detachable Microphone 3. Type-C charging cable 4. USB Dongle 5. 3.5mm LINE-IN audio cable (for wired connection if needed) [Technical Parameters] MIC Speaker Size Sensitivity Directivity Ø4.0 x 1.5mm -38dB ± 3dB Omnidirectional Impedance Size ≤ 2.2KΩ Ø40mm Sensitivity Impedance 115 ± 3dB 32Ω + 15% Frequency Response 20Hz ~ 20KHz 1000mAh 3.5mm 4-pin plug Battery Capacity Audio Plug Frequency 2.4G Net Weight USB Dongle about 282g 10g Effective Distance Max.
a. Plug the USB dongle into your device. Use an USB adapter if needed (USB adapter is not included in the package). Then the LED indicator on the USB dongle should flash into blue. b. Long press the power button on the headset for 3 seconds to turn on the headset. Then the USB dongle and the headset will connect with each other automatically, and the LED indicator on the USB dongle turns solid which indicate successful connection. c. Please insert the detachable mic if needed.
3 . Mic on/off There is a button marked with MIC on the headset. Press it once to turn off the MIC, and press again to turn on the MIC. When mic is on, the blue indicator at the end of the mic rod is on,which indicates that the mic is working. 4 . Charging When the headset is connected to power through the Type-C charging cable,it will be charged automatically, and the indicator is on in red. When it is fully charged, the indicator goes green. If the indicator is in yellow, it means the battery is low.
7 . Using with Computer Using with PC 2 1 3 1 Connect the USB dongle to an USB port on the computer. 2 Power on the headset. 3 When the LED indicator on the USB dongle turns solid, the headset is connected to the computer successfully. Follow the configuration steps below to make sure the headset can be used correctly.Right click on the Speaker icon at the bottom right of the desktop, choose Sound, then a dialog box will pop up. Click Playback and Recording, set “2.
picture 2 picture 1 8 .
1 Connect the USB dongle to an USB port on the PS4™. 2 Power on the headset. 3 When the LED indicator on the USB dongle turns solid, the headset is connected to the PS4™ successfully. Follow the configuration steps below to make sure the headset can be used correctly.Go to Settings in PS4™ main menu, choose Device > Audio Devices, set USB Headset (2.
[Trouble-shootings] Please check the following troubleshooting before sending the headset back for repair. Problems Probably cause Solutions low battery charge the headset fully something wrong with chip set restore the factory default settings USB dongle or USB adapter is not connected properly, or poor contact connect to another USB port to try again 2.4G AIR headset is not the defaulted audio device in your system set 2.
Sound Delays Battery does not last as long a s described Headset is of low battery charge the headset fully the electric quality of the new headset is not activated to maximization fully charge and discharge the battery a few more time. (acutal use time is affected by many factors like volume level, distance of connection, strength of signal..., so actual use time depends on the usage methods and strength) Warm prompt! 1 .
