Installation Guide

General Guidelines for Installing
Traditional Shutters
To deflect rain away from the structure, Louvered shutters
should be installed so the louvers face AWAY from the
structure when shutters are closed. (see diagram at right)
Shutters in closed position
Pick shutters to fit window & put
next to each window on top of
saw horses to make sure shutters
are paired properly. Lay two
shutters face down next to each
and prepare to install hinges.
1
Position & install upper holdback
clips 1" from top & center edge
of stile. Shutters over 58" require
2 sets of acorns; install similarly
at top.
3
Install hinges after determining
offset. Hinges are to be set at
top & bottom even with outside.
Drill holes with 1/8th pilot bit.
Be careful not to drill all the way
through shutter.
2
Install slide bolt. Turn shutters
over & line-up slide bolt edge
with shutter edge (see diagram
at right). Pre-drill 1/8 slot hole
(careful not to drill all the way
through). Install slide bolt with
screws. Shutters are now ready
for installation.
4
Shutter A Edge Shutter B Edge

Summary of content (2 pages)