Installation Guide
General Guidelines for Installing
Traditional Shutters
To deflect rain away from the structure, Louvered shutters 
should be installed so the louvers face AWAY from the 
structure when shutters are closed. (see diagram at right)
Shutters in closed position
Pick shutters to fit window & put 
next to each window on top of 
saw horses to make sure shutters 
are paired properly. Lay two 
shutters face down next to each 
and prepare to install hinges.
1
Position & install upper holdback 
clips 1" from top & center edge 
of stile. Shutters over 58" require 
2 sets of acorns; install similarly 
at top.
3
Install hinges after determining 
offset. Hinges are to be set at 
top & bottom even with outside. 
Drill holes with 1/8th pilot bit. 
Be careful not to drill all the way 
through shutter.
2
Install slide bolt. Turn shutters 
over & line-up slide bolt edge 
with shutter edge (see diagram 
at right). Pre-drill 1/8 slot hole 
(careful not to drill all the way 
through). Install slide bolt with 
screws. Shutters are now ready 
for installation.
4
Shutter A Edge Shutter B Edge


