- Wire Inc. Intelligent Gateway User Guide

Connect the provided AC power adapter from the Intelligent Gateway’s POWER port to an electrical

outlet. The green

POWER light on the front of the Intelligent Gateway should light up.

2. Connect the provided Ethernet cable from any available LOCAL ETHENET port on the Intelligent

Gateway to your computer’s Ethernet port.

3. Connect the provided ADSL Filter to the telephone socket.

4. Connect the provided telephone cable from the PHONE LINE port on the Intelligent Gateway to the

ADSL MODEM socket on the ADSL Filter.

This connects the internal DSL modem of the Intelligent Gateway to your DSL service provider. If you

have been using an external DSL modem, disconnect it as you will no longer need it.

5. (Optional). If you had a telephone connected to the telephone socket, you can reconnect it to the

PHONE port on the ADSL Filter.

Check your connections

Power-on your computer. When your computer is fully powered-up, verify the POWER and LOCAL

NETWORK indicator lights on the front of the Intelligent Gateway are green. If they are not, see

“Diagnosing connection problems” on page 110. The

BROADBAND LINK indicator light will not turn green

until the Intelligent Gateway software has been installed and an Internet connection has been established.

Continue from here to Step 3 “Install the Intelligent Gateway Software” on page 12.

Ethernet Connection

Requires a computer with an Ethernet port