- Wire Inc. Intelligent Gateway User Guide

Installing the Intelligent Gateway Setup Wizard on Windows PCs

Note: Close all programs before running the Intelligent Gateway Setup Wizard. The Intelligent Gateway

software must be installed on all computers in your network.

Place the Intelligent Gateway Setup Wizard CD in the CD-ROM drive of your computer and follow the

onscreen instructions. It may take up to one full minute for the Setup Wizard to start.

Starting the Setup Wizard manually on Windows PCs

After one minute, if the Setup Wizard does not run automatically, follow these steps:

1. Double-click the My Computer icon located on the desktop.

2. Double-click the icon that corresponds to your CD-ROM drive, then double-click Setup.exe.

3. Follow the onscreen instructions.

4. After the software installation is complete, your Intelligent Gateway is ready to use ADSL service and

the

POWER, LOCAL NETWORK, and BROADBAND LINK LEDs should be green.

Note: Refer to the “Using the Intelligent Gateway Network” chapter for information about the computers

on your network.