User Manual

28
4.3 Parameter adjustment about B
mode
The B mode is the most basic imaging mode, and the intensity of the echo signalofafault
interface in the body is displayed by the light spot brightness and dark. Thetwo-dimensional
image of the animal soft tissue organ of the moving body is displayed in real time, and the organ
morphology, the anatomical level and the adjacent relation can be clearly observed.
4.3.1 B mode image parameter
During B-mode image scanning, the image parameter area on the left side of the screen provides
real-time parameter information, which allows you to adjust the following parameters:
Adjustment method Parameter term
Control panel
adjustment
Gain, depth, one-button optimization
SoftKey adjustment
Frequency, extended imaging, frame-related, dynamic range,
effect, focus, spatial compounding, image enhancement,
pseudo-color map, left and right turning, up and down, sound
power, TGC, TSI
4.3.2 B mode image optimization
Gain
Resume
The total gain of the image in the two-dimensional mode ，displays in real time on the
image parameter area on the left side of the screen.
Effect By increasing the brightness of the gain image, more echo signals can be observed, but
at the same time, there will be more noise.。
Depth
Resume For adjusting the depth of the image display, the range of image depth can be
adjusted by different probes. The depth value is displayed in the image parameter
area on the left side of the screen in real time.
Effect The deeper the depth, the wider the observed tissue; the smaller the depth, the
shallower the observed tissue. When the depth increases, the frame rate decreases.
One-bond optimization
Resume According to the organization characteristics of the scanning area, the automatic
adjustment and optimization of the image effect is realized.