User's Manual

2 of 6
Baudrate Selection and Switches
The AIRcable Serial provides switches accessible from the top to select the baud rate. Switch up is on or '1'. Down means off or '0'.
The 4th switch is for hardware handshake. Up means hardware handshake is switched on, down means off.
SW1 SW2 SW3 Baud Rate
0 0 0 31.25 kbit/s
0 0 1 19.2 k
0 1 0 4.8 k
0 1 1 56.7 k
1 0 0 4.8 k
1 0 1 38.4 k
1 1 0 9.6 k
1 1 1 115.2 k
Configuration
When you receive an AIRcable Serial, the device must be configured.
A
IRcable devices support these modes:
Cable Mode
Service Mode
Manual Mode
Cable Mode
In cable-mode, two AIRcable devices are paired together and create a bond so no other device can interfere.
To pair two AIRcables use this simple procedure:
Press and hold the pairing button for 5 seconds. The AIRcable module automatically configures itself and starts in slave mode. The power LED
(green) will be on again and the connection LED (blue) starts flashing rapidly.
1.
Do this on both devices that are going to be paired.2.
On one device press the pairing button again (short click) to change the mode to master.
At this time the two devices will find each other, pair and establish a connection.
3.
The pairing information has been stored in flash and the two AIRcable modules will connect automatically when they are powered on. No other
device can connect to either AIRcable.
4.
A
dvanced Modes
The AIRcable Serial can be set into various advanced modes. Use the command line interface to change into these modes.