User's Manual

FCCUM99725
March 15, 2000
Rev -
6
Figure 5. Battery Charger
2.6 Battery Pack Replacement
. In the event that a battery pack will not remain
charged and needs replacement then refer to Figure 6. Place the remote on a flat surface
with the display face down exposing the battery pack compartment on the rear of the
remote. Remove the battery cover screw with a cross tip screw driver. Press down on the
battery pack connector clip on the pack in the unit. Gently remove the battery pack
connector clip and remove the battery pack. Insert the new battery pack connector clip
onto the mate within the unit ensuring that the clip snaps into place. Put the battery pack
into the battery compartment. Replace the battery cover and re-install the battery cover
screw.