User's Manual

PAC Configuration Manual
Wireless Matrix Corporation #102, 1530 - 27 Avenue NE Page 57 of 62
Document # xxx-xxx-xxx Calgary, AB, Canada T2E 7S6
2002.02.01 Ph. 403.250.3949 Fax [phone] www.wrx-ca.com
6 I/O Functionality and Configuration
The TPAC has seven terminals that can be used for general-purpose I/O. The TPAC has an
internal temperature sensor and an optional atmospheric pressure sensor. This section
describes the options available for each channel and the configuration of the channels.
I/O board points should be added with 9xx index to differentiate from external I/O points.
Use the following command to add points to access the internal I/O.
GDN ADd INT <pid> <index> <address> <f1> <f2> <f3> <f4> <type>
NOTE: PAC POW (Pause on wakeup) is recommended to allow transmitters to stabilize
after wake up. 1 to 2 seconds should be sufficient but each transmitter is different, so test
new a transmitter before installation.