User's Manual

Wireless Matrix Communicator 1000C
Wireless Mmatrix Proprietary and Confidential 5/20
Other Safety Precautions
Read and understand the complete Installation Guide, including the Safety
Precautions, prior to using the Wireless Matrix COMMUNICATOR 1000C Modem.
WARNING!
The following safety precautions must be observed during all phases of the
operation, usage, service or repair of the Communicator 1000C unit.
1. The Communicator 1000C must be operated at the voltages described in the
unit technical documentation.
2. The Communicator 1000C must not be mechanically or electrically changed or
modified. Use of all connectors should follow the guidance of the
Communicator 1000C technical documentation.
3. Replace fuse with same type and rating for protection against fire and
damage.
4. The Wireless Matrix Communicator 1000C is a Radio Frequency (RF)
generating device. Do not operate the unit when anyone is less 20cm of the
antenna, as noted in the Antenna Installation section of this guide. This could
result in personal injury.
5. Do NOT operate the Wireless Matrix Communicator 1000C unit in areas where
explosives are in use as the RF frequency could interfere with the operation,
causing hazardous conditions. Do NOT operate the Wireless Matrix
Communicator 1000C unit in areas where two-way radio communications is
prohibited.
6. Use discretion when determining the Wireless Matrix Communicator 1000C
installation point. After installation, ensure that all systems are functioning
properly. Consult vehicle dealer for further information.
CAUTION!
1. READ THIS MANUAL IN ITS ENTIRETY!
2. Keep all original Packing Materials.
3. Use caution when installing screws or drilling through the body of the
vehicle to avoid puncturing critical areas.
4. Install included grommets and weather sealant to protect cable
integrity and weatherproofing the area of penetration.
5. Follow the instruction enumerated in the Installation Section of this
guide to ensure proper hardware installation.
6. Ensure that the Wireless Matrix Communicator 1000C is installed in an
area with sufficient overhead clearance where it will NOT collide with
any other surfaces and in a location that will NOT affect the RF
transmission.
7. Pay close attention to the electrical power installation requirements
described in this guide. Failure to comply with the described section
could result in serious damage to the electrical system of the vehicle.