User manual
Replacing the battery pack
When you notice the X10DR sounding a small chirp,
it indicates the battery is nearly at and should be re-
charged. The unit will self power down after 30 minutes
when voltage drops to that level. When you notice this
occurring far more often than usual, it may mean it is
time for the battery to be replaced.
Like all re-chargeable products, periodic replacement
of the internal battery is required. The Secure Wireless
Microphone features a 1200mA Lithium Polymer battery
to provide typically 10-12 hours operation when used
with a busy radio channel.
To maximize the life of a Lithium battery its is better to
keep it topped up by returning it to the charger often
rather than waiting for it to rst go at - which was the
opposite case with older nickel based batteries. Typical-
ly you can expect to get about 500 plus full re-charge
cycles before the battery will require replacement.
The process is simple and should only take your radio
service supplier about 5 minutes to replace and test.
Replacement of the battery should be ONLY undertak-
en by a qualied service technician so as to ensure no
damage occurs to internal circuitry and to ensure the
housing’s weatherproof integrity is not compromised.
The replacement battery part number is: XSMB-C12:
1�2A LI-POL battery�
After replacement, the Secure Wireless Microphone
must be rst placed back into the mobile charger and
will initially need to be charged for 8 hours prior to com-
mencement of use. Depending on the situation it may
also need to be “re-connected” to the mobile charg-
ing unit)
X10DR
®
13